Welcome to the Kamloops Amateur Radio Club Website!

Please click on any of the top club links at the top of the page, or more informational links on the side. News is immediately below.

Follow-up visit to the Greenstone repeater on December 16, 2015 (UPDATED!)

Last night when I visited the repeater on Greenstone I discovered that the top guy wire on the east side had snapped off and was hanging loose. I wasn't sure how long it had been like this, but it needed to be repaired soon to prevent the tower from coming down if there was a severe wind storm and/or heavy ice loading. Before work today I stopped in at Shaw's Enterprises and asked them what they would recommend for a temporary fix until we can do a proper splice. They were very helpful and I'd like to send a big "thank you!" to the guys at Shaw's! In less than 15 minutes I was out the door with five feet of 3/8" wire rope with a swaged loop on one end and a half-dozen top-quality wire rope clamps (total cost: $21.32). They also walked me through the right way to install rope clamps .

It was minus 13C and a windy at the top last night, but the sky was absolutely clear and there was a sliver of moon and a million stars right above me. A very scenic, albeit a bit chilly, environment for the repair.

I had come prepared with more tools than I ended up needing, because once you're up at the top of Greenstone, you can't just walk into the garage and grab something you forgot! The turnbuckle wasn't rusted or corroded, so I didn't need the penetrating oil, torch, or the myriad of crescent wrenches and other stuff I had packed "just in case". The repair went fairly quickly, despite some fumbling with tools and the nuts (not one was dropped in the snow!), which were a little hard to handle with warm gloves on my hands. You can see pictures of the "field-expedient repair" below.

It took a little less than two hours to snowshoe in, splice the guy wire, loosen the turnbuckle, hook the repaired guy wire to the turnbuckle, tighten and tie off the turnbuckle, take a bunch of photos, then pack up and walk out. I did stop a few times during the evening to admire the awesome view of Kamloops from the top of Greenstone, and to marvel at the stars. I left home just before 6pm, and was home about 9:30pm, so it made for a nice evening adventure!

Thank you to Bill, VE7WWW, who monitored the radio all evening to make sure I made it safely home from Greenstone.

Myles
VE7FSR

UPDATE!

I went up to the tower on Sunday, to see how the things looked in the daytime. I checked the torque on the wire rope clamps (they were OK) and noticed something I hadn't seen in the dark -- I didn't quite get all the clamps on the wire splice lined up in a nice row! I took some photos (see below) in the sunshine, so you can get a better idea of how things look up the hill in winter.

Carl Luetzelschwab (K9LA) Propagation Presentation

On November 5, 2015 the Kamloops Amateur Radio Club hosted a special meeting where propagation expert and experienced DX'er Carl Luetzelschwab (K9LA) presented a webinar on radio propagation.

Carl has very kindly offered to share his presentation with the membership, and it is available for download below.

Visit to the Greenstone repeater, December 15, 2015

I made an evening trip up to the Greenstone repeater (VE7RKA) on December 15, to do some troubleshooting on some UHF interference that was causing problems for the Shuswap Amateur Radio Club repeater on Fly Hills. After slogging in to the repeater shack on snowshoes, I was surprised to see a strange looking "wire" covered in frost, hanging from the tower.

After I dug out the door to the shack, I grabbed my flashlight and walked over to take a look. Much to my surprise it was the top guy wire from the east side of the tower -- it had broken off at the turnbuckle! And it was draped across several antennas on the tower, including two of the UHF link antennas! I wonder if this could have been the cause of the issue with the east UHF link to Salmon Arm!?

I managed to get it moved off the antennas and tied down right against the tower, but it was a little exciting because as I waved the loose guy wire around, clumps of frost and ice were dislodged from the top of the tower and showered down on me. And no, I hadn't thought to bring a helmet!

I plan to stop in Wednesday morning at Shaw's Enterprises and get them to make up a temporary "splice" that I can u-bolt to the broken guy wire and get it re-attached to the turnbuckle. At some point we will need to find someone who can do a proper splice on the guy wire (know anyone who could do this?). Wednesday night after work I will head back up the mountain and install the temporary splice, and inspect the other guy lines for damage. Anyone interested in joining me?

73,
Myles
VE7FSR

October Club Meeting - Antenna Night and Swap & Shop

The October club meeting will be "Antenna Night", and we will be having an informal Swap & Shop.

Myles, VE7FSR, will be bringing an Anritsu Site Master antenna analyzer if anyone wants to sweep a hand held antenna or mobile whip on your vehicle. The Site Master gives a visual SWR sweep of the antenna which is helpful for tuning/trimming an antenna, or if you want to know the 2:1 bandwidth of an antenna.

Myles and Vern, VE7VGO, will also be talking about some antenna experiments they have been making with OCF (Off-Centre Fed) dipoles and End-Fed HF antennas.

If you have an interesting antenna you want to show off, or have an antenna problem or question that you need some advice with, then please attend the meeting at St. George's Church cottage. https://goo.gl/nEHQ13

Also, if you have something to sell, swap, or give away, we will be holding an informal Swap & Shop at the end of the meeting.

As always, there will be donuts! :-)

Update on the TI audio chip + Windows bug

Hi all,

An update was posted which shows a more permanent fix for those of us with these affected older-model TI sound chips in our devices.

https://www.youtube.com/watch?v=GwFUUMrPazA

Enjoy, and 73!
-Adam

Huge Windows bug ruining receive performance on digital modes, fix discovered

Hi all,

I came across this this afternoon and it's worth spreading the news on - many or most amateurs utilizing remote sound interfaces with numerous models of TI chips are likely having poor receive performance in all versions of Windows from Vista on up.

Please have a look at this video and this story and discussion at Reddit.

As the Reddit post shows, this affects all Signalink USB units, all ICOMs, Kenwoods and Yaesu's with built in USB audio, as well as the SCU-17 interface, and very likely other devices.

The fix is handy to know, and hopefully if there's enough noise on this perhaps we can push Microsoft for a fix. (Perhaps that's wishful thinking)

73 all,
Adam

The proposed Field Day site is definitely a go - see you there!

Hello all,

Please see the attached information on this year's field day site (as well as the previous article) for information on how to get there.

The Field Day schedule will be similar to past Field Days with set up beginning Friday June 26 afternoon and evening. We will finish set up Saturday June 27 morning and start operating at noon until noon Sunday June 28. Then it’s time to take everything apart.

As usual we will take a break from operating for our pot luck dinner around 5:00 PM on Saturday. Then back at it “CQ field day de VE7UT“.

73,
Adam

Proposed Field Day 2015 location

Hello all,

Please see the below information on the proposed field day site location for this year. In the frame below you will see the google maps driving directions (hit 'more options' to bring it up larger in the browser and get the full driving directions). Also attached are screen shots from google earth as well as a KMZ file that will open up the location in google earth if you have it installed.

Please send us feedback if you have any, and we'll post further updates as they become available.

73,
Adam

KARC Club meeting this Thursday evening and IRLP node 1080 outage

Hello all,

It's that time of the month again, our club meeting is coming up this Thursday evening the 4th at the St. George's church at the intersection of Royal Ave. and Knox St. in North Kamloops at 7:30pm. Any and all guests are more than welcome.

Also our local IRLP node 1080 will be off the air for a few days and then may have limited outbound-only operating for a bit after that. We will post more on this as it develops.

73,
Adam

VE7RLO Lolo repeater is back on the air again

Hello all,

Thanks to Myles, Lolo was brought back on the air last Monday.

Enjoy!

73

Pages

Subscribe to Kamloops Amateur Radio Club RSS